This is the screen protector I got: http://cgi.ebay.com/Anti-Glare-Screen-P ... 3cb2572d12
This is the case I got: http://newmp3technology.com/a101case.htm
Anyone that was wondering what they actually looked like on a real device, here you go.
----------------------- START NEW PHOTOS -----------------------
My personal impression of the case: The case is sturdy. The leather feels very solid. It doesn't feel 'cheap' at all.
The A101 fits well inside the case, quite snug, not much 'wiggle room'.
The right side seems to stick slightly further into the viewing area (you can see some of the bezel from the right), and I can't seem to get it to stay centered. This does not affect the camera, or using the screen at all (even the farthest part to the left). It's just kind of annoying if you want it to be perfectly centered.
The closing strap is quite sturdy as well, almost too sturdy. When closing it up (flipping it forward to cover the front), it holds tight, even though it only slides into place.
When closing the strap from the back (to stand it upright to watch), it's actually kind of difficult to put the strap in. Not because of the case, but because the strap is quite rigid (I'm sure the holder piece will stretch a bit). Once the strap is in place to stand it up though, it's definitely sturdy.
My personal impression of the screen protector: It gets the job done. Cuts down on glare by quite a bit (I sit at my table under a 5-bulb hanging light about 4 feet above me).
The touchscreen isn't effected at all by the protector, still just as responsive as ever (can hover your finger ~1mm away and have it activate).
The protector fits perfectly over the touch part of the screen if placed carefully. It's cut to be just slightly smaller than the actual screen area. It sits in ~0.4mm from the bezel on all sides.
I hope this helps anyone that's questioning whether or not they should get these accessories for their A101.
Note: These pictures were taken when the case came in right out of the cold (~12 degrees outside, I live in Alaska). The case was rigid and hard, so the 'bend' you see in some of the pictures is due to that.
... so it easier to see how the anti-glare cover works
