Forum.ArchosFans.com
http://forum.archosfans.com/

Right-angle plug for the 10G2?
http://forum.archosfans.com/viewtopic.php?f=87&t=66734
Page 1 of 1

Author:  DG19075 [ Tue Sep 04, 2012 4:00 am ]
Post subject:  Right-angle plug for the 10G2?

I'd love to find a right-angle plug to replace the stock in-line one on the end of the charger cord going into the tablet. The inline unit puts too much stress on the male jack in the tablet, breaking the center pin and ultimately the solder connections on the circuit board. Has anyone found such a plug or a right angle adapter?

Thanks!

Dave Gardiner

Author:  viking [ Tue Sep 04, 2012 6:33 am ]
Post subject:  Re: Right-angle plug for the 10G2?

Dunno about L shapes, but cant u wrap the cord back to the plug and tie a slipknot to grasp it at a right angle or tape it closer to the base? I assume you are talking about charging while using, and the weight of cylinder or cord tension is side pulling with too much leverage. I wish they could put that anti interference cyl further down the cord.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/