Forum.ArchosFans.com

Unofficial Archos Support Forum
It is currently Thu Apr 02, 2020 2:23 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 3 posts ] 
Author Message
 Post subject: eGalax calibration
PostPosted: Wed Dec 01, 2010 7:05 pm 
Offline
Archos User
Archos User

Joined: Wed Dec 01, 2010 6:46 pm
Posts: 125
Hi! Just bought Archos 9. Dod clean installation of win 7. Installed eGalax touch software, not sure how to run the sotware. When opened it shows circle with 4 arrows; what must I do next?


Top
   
 Post subject: Re: eGalax calibration
PostPosted: Thu Dec 02, 2010 3:08 am 
Offline
Archos User
Archos User

Joined: Wed Dec 01, 2010 6:46 pm
Posts: 125
Not sure if anyone else came across the above mentioned issue, but just in case here's how I solved the issue. I used the included stylus and pressed down inside the calibration point until it went to 100%. After releasing, the calibration point automatically moved to a different corner on the screen. I repeated the process each time until I had calibrated all four corners.


Top
   
 Post subject: Re: eGalax calibration
PostPosted: Wed Dec 08, 2010 6:37 pm 
Offline
Archos User
Archos User

Joined: Wed Dec 01, 2010 6:46 pm
Posts: 125
Open the eGlass Touch software > Go to Tools > 4 Point Calibrate > Using finger or the Stylus (stylus is more precise) press on the center of red target until OK appears > The target will move to the next corner...just repeat the process each time the target moves (four times)


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 3 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited