AV420 will not charge...blown component
Page 1 of 1

Author:  mastervodkaman [ Fri Apr 29, 2011 5:27 pm ]
Post subject:  AV420 will not charge...blown component

I have an aV400 that will not charge. I have opened the unit up and a small surface mounted component near the charging pin appears to have blown.............can anyone please tell me the details of this component so I can replace it.

many thanks

Author:  fredc [ Fri Apr 29, 2011 7:35 pm ]
Post subject:  Re: AV420 will not charge...blown component

It is most likely a surface mount fuse since the MMJB and AV300 had the same. You could check by putting a temporary short around it and seeing if the charging light then comes on. I don't know the value but max peak current on the larger 2.5 hard drives could be just over an amp so I would guess 1 or 1.5A might be suitable?

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited